Black grouse does NFT blue cheese as usual!

[GMO]

You wanna dim on voltage and keep your current constant mate

The outside one is current. Inside is voltage

Sent from my SM-G900F using Tapatalk

[Nanook]

gmo? invis said both max?

[GMO]

gmo? invis said both max?

Max the current. Dim on voltage if your gonna dim

Mine reads 170w when both on full tho

Sent from my SM-G900F using Tapatalk

[Nanook]

hmmmm, I really need one of them plug things to check

[GMO]

Yea invisible said the setup isn't able to produce that much draw but I tested on 3 units and did the maths manually and got 170w

I think I'll have to mention it again

Sent from my SM-G900F using Tapatalk

[Invisible Sun]

gmo? invis said both max?

Max the current. Dim on voltage if your gonna dim

Mine reads 170w when both on full tho

Sent from my SM-G900F using Tapatalk

GMO you must be reading it wrong or something. I meant to message you about it but forgot. Glad i'v seen this as you've reminded me.

You can not run the hlg 120h 48A at a higher wattage than 120w, the driver has saftey features which will cut it out if the wattage exceeds 120w

The V/O on the 120h 48A will increase voltage or decrease voltage by 10% this will not increase wattage, the I/O will not increase the wattage either as it only dims the current.

Im not sure what what youre doing pal ?

I

[GMO]

gmo? invis said both max?

Max the current. Dim on voltage if your gonna dim

Mine reads 170w when both on full tho

Sent from my SM-G900F using Tapatalk

GMO you must be reading it wrong or something. I meant to message you about it but forgot. Glad i'v seen this as you've reminded me.

You can not run the hlg 120h 48A at a higher wattage than 120w, the driver has saftey features which will cut it out if the wattage exceeds 120w

The V/O on the 120h 48A will increase voltage or decrease voltage by 10% this will not increase wattage, the I/O will not increase the wattage either as it only dims the current.

Im not sure what what youre doing pal ?

I

Cheers dude

I'm really confused cos they read correctly on the 250w and my diy board

It's pulling 245.7 volts at 0.724a and the readout say 176.1w

Sorry for cluttering your thread BG lol

Sent from my SM-G900F using Tapatalk

[Nanook]

Don't be sorry.... This info is good mate. Other people might be asking the same things.... That or your just too stoned to read

[GMO]

very possible but I check on 3 different meters

ive chucked it up to max now anyways

see what happens

[Nanook]

Gave half them a small trim tonight