Vapeing weed
- Vador
- Registered User
- Posts: 2580
- Joined: Thu Sep 30, 2021 10:47 pm
- Has thanked: 916 times
- Been thanked: 1209 times
- Contact:
- Status: Offline
Re: Vapeing weed
Just a thought but the lids can be quite tricky to get off the capsules when they are new, best way I found is flick it off with your thumb nail like your popping the head off a daisy, after a couple of uses they free up real nice.
Also if you use your fingers to put the lids on be careful when your pushing down on it, if you’d dent the top of the capsule you end up with a void between the lid and the screen in the vape, this little void makes it possible for debris to escape the capsule as you inhale, it’ll clog up the screen over time.
I use a flat ended pencil to ream out the inside of any dented capsules and make them flat again.
The filling set comes with a special tool for putti the lids on, even if you don’t get the filling set then that little tool is worth getting just to keep your capsules in good condition
Also if you use your fingers to put the lids on be careful when your pushing down on it, if you’d dent the top of the capsule you end up with a void between the lid and the screen in the vape, this little void makes it possible for debris to escape the capsule as you inhale, it’ll clog up the screen over time.
I use a flat ended pencil to ream out the inside of any dented capsules and make them flat again.
The filling set comes with a special tool for putti the lids on, even if you don’t get the filling set then that little tool is worth getting just to keep your capsules in good condition
░█▒█▒▄▀▄░█▀▄░▄▀▄▒█▀▄
░▀▄▀░█▀█▒█▄▀░▀▄▀░█▀▄
Drugs and Alcohol are never the answer! Unless the question was “what am I doing tonight”.
░▀▄▀░█▀█▒█▄▀░▀▄▀░█▀▄
Drugs and Alcohol are never the answer! Unless the question was “what am I doing tonight”.
- Vador
- Registered User
- Posts: 2580
- Joined: Thu Sep 30, 2021 10:47 pm
- Has thanked: 916 times
- Been thanked: 1209 times
- Contact:
- Status: Offline
Re: Vapeing weed
Here you go this thing
https://www.storz-bickel.com/en/parts-a ... g-capsules
The whole filling set is good though, sounds a lot but you get all sorts of bits with it
https://www.storz-bickel.com/en/parts-a ... g-capsules
The whole filling set is good though, sounds a lot but you get all sorts of bits with it
- Treetrunk
- Registered User
- Posts: 3300
- Joined: Fri Jul 03, 2020 4:45 pm
- Has thanked: 1897 times
- Been thanked: 2359 times
- Status: Offline
Re: Vapeing weed
I don't think I'll bother with the capsules.Vador wrote: ↑Thu Oct 28, 2021 12:11 pmJust a thought but the lids can be quite tricky to get off the capsules when they are new, best way I found is flick it off with your thumb nail like your popping the head off a daisy, after a couple of uses they free up real nice.
Also if you use your fingers to put the lids on be careful when your pushing down on it, if you’d dent the top of the capsule you end up with a void between the lid and the screen in the vape, this little void makes it possible for debris to escape the capsule as you inhale, it’ll clog up the screen over time.
I use a flat ended pencil to ream out the inside of any dented capsules and make them flat again.
The filling set comes with a special tool for putti the lids on, even if you don’t get the filling set then that little tool is worth getting just to keep your capsules in good condition
I like it better just with the reducer.
I'll just get spare screen's for the reducer. My hands are like JCB shovels and them capsules are far too fiddly I'm more than happy with just the reducer. Thanks mate
- Vador
- Registered User
- Posts: 2580
- Joined: Thu Sep 30, 2021 10:47 pm
- Has thanked: 916 times
- Been thanked: 1209 times
- Contact:
- Status: Offline
Re: Vapeing weed
No worries, I misread the part that you aren’t fussed about the capsules so ignore me.
one word of advice, when cleaning it try not to remove the metal reducer from the orange plastic.
I took mine out only a handful of times for cleaning when one of the small plastic tabs that hold it in broke off, not log after that another broke then the last one, got to the point the reduced would just fall out, was sat there one day in shorts and tshirt having a vape, when finished I emptied it when the reduced fell out. Instant reaction is to try and stop it falling by catching it between my legs, yeah that was a bad move 200c piece of metal on bare legs is not a nice feeling lol
one word of advice, when cleaning it try not to remove the metal reducer from the orange plastic.
I took mine out only a handful of times for cleaning when one of the small plastic tabs that hold it in broke off, not log after that another broke then the last one, got to the point the reduced would just fall out, was sat there one day in shorts and tshirt having a vape, when finished I emptied it when the reduced fell out. Instant reaction is to try and stop it falling by catching it between my legs, yeah that was a bad move 200c piece of metal on bare legs is not a nice feeling lol
- Treetrunk
- Registered User
- Posts: 3300
- Joined: Fri Jul 03, 2020 4:45 pm
- Has thanked: 1897 times
- Been thanked: 2359 times
- Status: Offline
Re: Vapeing weed
I'll definitely bare that in mindVador wrote: ↑Thu Oct 28, 2021 2:21 pmNo worries, I misread the part that you aren’t fussed about the capsules so ignore me.
one word of advice, when cleaning it try not to remove the metal reducer from the orange plastic.
I took mine out only a handful of times for cleaning when one of the small plastic tabs that hold it in broke off, not log after that another broke then the last one, got to the point the reduced would just fall out, was sat there one day in shorts and tshirt having a vape, when finished I emptied it when the reduced fell out. Instant reaction is to try and stop it falling by catching it between my legs, yeah that was a bad move 200c piece of metal on bare legs is not a nice feeling lol
I'll order one as I'm bound to break it.
- FX
- Registered User
- Posts: 2120
- Joined: Wed Jun 24, 2020 8:41 pm
- Location: Planet earth (unverified)
- Has thanked: 1054 times
- Been thanked: 960 times
- Status: Offline
Re: Vapeing weed
Yeah, I've gone through a fair few of the orange holders lol...
“Although I am a typical loner in daily life, my consciousness of belonging to the invisible community of those who strive for truth, beauty, and justice has preserved me from feeling isolated.” - Albert Einstein
- Vador
- Registered User
- Posts: 2580
- Joined: Thu Sep 30, 2021 10:47 pm
- Has thanked: 916 times
- Been thanked: 1209 times
- Contact:
- Status: Offline
Re: Vapeing weed
Do you find the little clips break @FX?
Apart from them clips everything else seems to be holding up at the moment on mine.
Only time will tell though I guess
Apart from them clips everything else seems to be holding up at the moment on mine.
Only time will tell though I guess
- FX
- Registered User
- Posts: 2120
- Joined: Wed Jun 24, 2020 8:41 pm
- Location: Planet earth (unverified)
- Has thanked: 1054 times
- Been thanked: 960 times
- Status: Offline
Re: Vapeing weed
The clips break so it's not held in tight and the handle snaps off lol, the rest of it seems to be pretty solid, I did have it kinda catch fire though lol.... The cable just inside the unit got worn from years of use, I just opened it up and removed the worn section of cable, works a treat again now...
- Vador
- Registered User
- Posts: 2580
- Joined: Thu Sep 30, 2021 10:47 pm
- Has thanked: 916 times
- Been thanked: 1209 times
- Contact:
- Status: Offline
Re: Vapeing weed
I did wonder how long it’ll be before the handle breaks off, I try not to use it for that reason, I just grab it by the knobbly bits and twist
- FX
- Registered User
- Posts: 2120
- Joined: Wed Jun 24, 2020 8:41 pm
- Location: Planet earth (unverified)
- Has thanked: 1054 times
- Been thanked: 960 times
- Status: Offline