I've been doing a lot of seeds and I've taken clones with great success using the standard peat and rockwool way but I've recently moved onto aeroponics so thought aeroponics cloner would fit my current style of growing.
I've never used one before so wanted to open a discussion to see how you guys run aeroponic cloners and get some general knowledge on how to proceed.
I've bought a 20 site X-stream propagator but they were out of the 20site tops so I bought a 12 to run a trial run. I'm using RO water as per all my grows. Here's how I kicked this off.
Filled the res with about 4ltr of RO water.
Added CaMg to bring the PPM up to around 100
Added 2ml of Nitrozyme
Added 1.5ml of Bio Roots
Added 1.5ml of Ferro Enzyme Plus
PH the water to 6
Take the clones from the bottom of thr plant, cut the branch down to around two nodes plus a bit of real estate. Trim the leaves in half to stop transpiration while rooting, score the bottom of the cutting 2-3 times with a scalpel to expose some tissue below the epidermis. Dip in some rooting gel and place in the neoprene leaving about 1-2cm below the ground.
I did consider adding some superthrive but decided not to. So what do you think guys? Did I do something wrong? What's your secret sauce?
These photos are 24 hours after putting them in the propagator.