Tripp's tincture
- Trippster62
- Registered User
- Posts: 283
- Joined: Wed Jan 26, 2022 1:18 am
- Location: USA
- Status: Offline
Tripp's tincture
We all have to work with what we have. I understand that not everyone has the same equipment available. You can modify this to suit your needs.
For me, nowadays, it's all about what I have to start with. Whether it's frosty trim, larfy bud, or fresh frozen whole plant we are separating the plant material from the trichomes. This is always best accomplished with frozen material.
I have been doing alcohol extraction since 1983, both Isopropyl and Ethyl. I now stick to solventless extraction for the most part. However, some good 190 proof grain alcohol is what I use for my tincture.
I start with rosin since I got my press, but I've started with bubble hash, dry sift, bho, hash oil or some other type of concentrate.
In this case I have 4.6 g of an ethanol extraction that the lid on the jar had been left loose on and got pushed to the back of my drawer for a while. By the time I got back to it all of the terps had evaporated and it had no real flavor although it still would get you quite elevated.
That was then broken into small pieces and spread out on parchment paper and put in the oven at 250F, 121C for 40 minutes.
This is what it looked like coming out of the oven.
Here's the part most don't like. Time to do some math. I don't have test results for the extractions I make so I use some averages mixed with some assumptions and make a guesstimate. Generally speaking I'll usually guesstimate rosin, bho, or any type of hash oil at 70%. Lower qualities of bubble hash or dry sift may be as low as 40%.
I try to make my tincture around 500mg per ounce or 30ml. So at 70% for this material that will be 700mg per gram provided we have fully decarbed.
4.6 g x 700mg =3200mg
3200mg ÷500=6.44 oz, 190ml of grain alcohol needed.
But let's say that I was off on my guesstimate and my starting material was only 60% ... well then my oz of tincture would only be 428mg, or it happened to be 80% I'd be at 571mg.
So 1/4 teaspoon dose =
Low end 17.3mg
Middle 20.8 mg
High end 23.79
So if I call that a 20mg dose I won't be too disappointed if it's on the low end and I won't be overwhelmed if it's on the high side.
Math problems over, back to the fun.
Next I drop my decarbed in the appropriate amount of grain alcohol.
You can hand stir until everything is fully dissolved in the alcohol. In our case my wife bought this neet little hotplate with magnetic stirrers. With the hotplate off we just let the magnetic stirrer do its thing.
Here is our finished product.
From here you can further refine the product by the winterization process. Simply place this in the freezer allowing the alcohol to reach a temperature of -5F -20C. I usually let it sit 24 - 48 hrs to allow the fats, waxes, and lipids to precipitate to the bottom. Filter this through a coffee filter, preferably in the freezer.
For me, nowadays, it's all about what I have to start with. Whether it's frosty trim, larfy bud, or fresh frozen whole plant we are separating the plant material from the trichomes. This is always best accomplished with frozen material.
I have been doing alcohol extraction since 1983, both Isopropyl and Ethyl. I now stick to solventless extraction for the most part. However, some good 190 proof grain alcohol is what I use for my tincture.
I start with rosin since I got my press, but I've started with bubble hash, dry sift, bho, hash oil or some other type of concentrate.
In this case I have 4.6 g of an ethanol extraction that the lid on the jar had been left loose on and got pushed to the back of my drawer for a while. By the time I got back to it all of the terps had evaporated and it had no real flavor although it still would get you quite elevated.
That was then broken into small pieces and spread out on parchment paper and put in the oven at 250F, 121C for 40 minutes.
This is what it looked like coming out of the oven.
Here's the part most don't like. Time to do some math. I don't have test results for the extractions I make so I use some averages mixed with some assumptions and make a guesstimate. Generally speaking I'll usually guesstimate rosin, bho, or any type of hash oil at 70%. Lower qualities of bubble hash or dry sift may be as low as 40%.
I try to make my tincture around 500mg per ounce or 30ml. So at 70% for this material that will be 700mg per gram provided we have fully decarbed.
4.6 g x 700mg =3200mg
3200mg ÷500=6.44 oz, 190ml of grain alcohol needed.
But let's say that I was off on my guesstimate and my starting material was only 60% ... well then my oz of tincture would only be 428mg, or it happened to be 80% I'd be at 571mg.
So 1/4 teaspoon dose =
Low end 17.3mg
Middle 20.8 mg
High end 23.79
So if I call that a 20mg dose I won't be too disappointed if it's on the low end and I won't be overwhelmed if it's on the high side.
Math problems over, back to the fun.
Next I drop my decarbed in the appropriate amount of grain alcohol.
You can hand stir until everything is fully dissolved in the alcohol. In our case my wife bought this neet little hotplate with magnetic stirrers. With the hotplate off we just let the magnetic stirrer do its thing.
Here is our finished product.
From here you can further refine the product by the winterization process. Simply place this in the freezer allowing the alcohol to reach a temperature of -5F -20C. I usually let it sit 24 - 48 hrs to allow the fats, waxes, and lipids to precipitate to the bottom. Filter this through a coffee filter, preferably in the freezer.
If you reduce the amount of hash you consume in order to preserve your glass you've missed the whole point.
The hash is more important than the glass.
The hash is more important than the glass.
- MrNice
- Respected Member
- Posts: 10709
- Joined: Fri Apr 24, 2020 7:25 pm
- Status: Offline
- Trippster62
- Registered User
- Posts: 283
- Joined: Wed Jan 26, 2022 1:18 am
- Location: USA
- Status: Offline
Re: Tripp's tincture
Made a new batch from rosin that, for one reason or another, was not going to be dabbed by me. A portion came from hash that I made from some overdried material that I got from another grower. A lot of green in the hash before it was pressed. This run was cloudy after the above steps so winterization is needed. Because of the green I will also solarize it.
This is what it looked like after being in the freezer for 24hours. Notice the accumulation of fats, waxes, and lipids at the bottom of the jar.
I put a coffee filter in a second jar. I used the jar lid ring to secure the filter in place. This was then put back into the freezer. Filtering is slow so both jars stay in the freezer so that everything stays cold.
This is all of the unwanted fats, waxes, and lipids plus any other contaminates larger than the pores of the filter. I tried to get a shot showing how thick the layer of junk was.
Time for "solarization" (my term). I now set my filtered tincture in the sun. It is actually the uvb in the sunlight that does the work. Exposure to uvb light will cause chlorophyll to degrade removing any green coloration from the final product. I suppose a reptile basking lamp would probably work too.
After an hour in the sun there is no green tint to the tincture. This process may take more time or less time depending on how much chlorophyll was in the solution to begin with. The change will go from green to amber (this is where I want it) to reddish. It is still fine to use even if it starts to go red, just don't let it sit in the sun any longer than necessary as this will also start to degrade the THC into CBN. A little CBN is OK to me but not too much as it is sleepy time medicine.
This is what it looked like after being in the freezer for 24hours. Notice the accumulation of fats, waxes, and lipids at the bottom of the jar.
I put a coffee filter in a second jar. I used the jar lid ring to secure the filter in place. This was then put back into the freezer. Filtering is slow so both jars stay in the freezer so that everything stays cold.
This is all of the unwanted fats, waxes, and lipids plus any other contaminates larger than the pores of the filter. I tried to get a shot showing how thick the layer of junk was.
Time for "solarization" (my term). I now set my filtered tincture in the sun. It is actually the uvb in the sunlight that does the work. Exposure to uvb light will cause chlorophyll to degrade removing any green coloration from the final product. I suppose a reptile basking lamp would probably work too.
After an hour in the sun there is no green tint to the tincture. This process may take more time or less time depending on how much chlorophyll was in the solution to begin with. The change will go from green to amber (this is where I want it) to reddish. It is still fine to use even if it starts to go red, just don't let it sit in the sun any longer than necessary as this will also start to degrade the THC into CBN. A little CBN is OK to me but not too much as it is sleepy time medicine.
- TommyT
- Known User
- Posts: 2048
- Joined: Tue Oct 15, 2019 4:56 am
- Location: Orion Arm of the Milky Way galaxy
- Status: Offline
Re: Tripp's tincture
Nice! I'm following along.
Purple Punch From Seedstockers
The other day when I was high I solved one of the world's greatest problems.
Unfortunately five minutes later I forgot what I was doing.
-
- Inactive Account
- Posts: 55522
- Joined: Tue Oct 24, 2017 8:46 pm
- Location: floating on a pink cloud
- Contact:
- Status: Offline
Re: Tripp's tincture
Amazing write up and info , thanks hun very interesting
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- MrNice
- Respected Member
- Posts: 10709
- Joined: Fri Apr 24, 2020 7:25 pm
- Status: Offline
Re: Tripp's tincture
DAmmm trip you know shed loads sweeet man love it
- Keeno
- Respected Member
- Posts: 25537
- Joined: Sat Oct 07, 2017 10:11 pm
- Contact:
- Status: Online
Re: Tripp's tincture
Very good write up. Thank you fur sharing @Trippster62.
I'll make this topic a sticky
I'll make this topic a sticky
- JJ
- New Years Grow Off Winner
- Posts: 7316
- Joined: Sat Aug 22, 2020 6:39 pm
- Location: Usa ohio
- Status: Offline
Re: Tripp's tincture
I do this also but not down to this science,,luv the tincture,hard to find the 190 in ohigho at times,great post
- MommaB
- Plant Of The Year Winner 2022
- Posts: 8300
- Joined: Sat Jun 29, 2019 7:38 pm
- Location: Texas
- Status: Offline
Re: Tripp's tincture
This is awesome!!! Great info on here
A Heart is not judged by how much you love; but by how much you are loved by others- The Wizard of Oz