Tommy's first try at Bubble Hash and Temple Balls

Make your own hashish, hash, resin & solid
User avatar
FX
Known User
Posts: 2122
Joined: Wed Jun 24, 2020 8:41 pm
Location: Planet earth (unverified)
Has thanked: 1493 times
Been thanked: 1555 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by FX »

Okay, I'm convinced... Gonna try this next run... I have the exact same scales
These users thanked the author FX for the post (total 2):
TommyT (Wed May 12, 2021 4:05 pm) • Mrs Beefheart (Wed May 12, 2021 5:41 pm)

TommyT
Known User
Posts: 2051
Joined: Tue Oct 15, 2019 4:56 am
Location: Orion Arm of the Milky Way galaxy
Has thanked: 1596 times
Been thanked: 1370 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by TommyT »

Marcus wrote: ↑
Wed May 12, 2021 7:21 am
Nice Tommy. How are you drying it?

I like to pop my balls in the freezer for a few hours then get the fine cheese grater on them over a bit of baking parchment and leave them to air dry for a week in the house.

Then work them back together with a hit of hand heat and a squeeze.
As far as drying it... I might need help on this.
I THOUGHT that once the hash was in ball form that's all you needed to do.
I let the hash dry for a day when it was in powder form.
Then I rolled it with a hot bottle of water to get it sticky and then rolled it in my hands to make the ball.
Maybe that's why the only two balls I got from it was the 20 and 73 micron from the first run.

Any advice?
These users thanked the author TommyT for the post:
Marcus (Wed May 12, 2021 5:10 pm)
Purple Punch From Seedstockers
The other day when I was high I solved one of the world's greatest problems.
Unfortunately five minutes later I forgot what I was doing.

Marcus
GR420 Leg End
Posts: 5241
Joined: Thu Nov 29, 2018 2:25 pm
Has thanked: 2463 times
Been thanked: 4662 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by Marcus »

TommyT wrote: ↑
Wed May 12, 2021 4:17 pm
Marcus wrote: ↑
Wed May 12, 2021 7:21 am
Nice Tommy. How are you drying it?

I like to pop my balls in the freezer for a few hours then get the fine cheese grater on them over a bit of baking parchment and leave them to air dry for a week in the house.

Then work them back together with a hit of hand heat and a squeeze.
As far as drying it... I might need help on this.
I THOUGHT that once the hash was in ball form that's all you needed to do.
I let the hash dry for a day when it was in powder form.
Then I rolled it with a hot bottle of water to get it sticky and then rolled it in my hands to make the ball.
Maybe that's why the only two balls I got from it was the 20 and 73 micron from the first run.

Any advice?
WHat I do (and I'm no expert BTW) is...

Scrape the hash into small blobs on the pressing screen. Fold the screen over, jeyes cloth or towel underneath it (nothing fluffy, a kitchen tea towel is good) and a jeyes cloth or towel on top... Then I press the shit outta it to get most of the water out and into the towels.

Straight in the freezer then till rock solid, then I grate it with a fine grater over some parchment paper and pop it on a cake cooling rack in the lounge for a week, changing the paper after the 1st day and turning over the hash a couple of times a day so it all dries evenly.

If the hash starts getting warm, it won't grate so move your fingers to different parts to hold it and pop it back in the freezer when it gets difficult to grate too.

ImageImageImage

To press it when dry, I just put some in the palm of my left hand and then grip my thumb onto of the hash and make some beautiful friction...

Keep working it baby and then work the little bits into bigger bits you'll end up with stuff that will break windows.

Image

Hope this helps man.

Smoking hash that's full of water and not dried proper makes me cough my hole up. :lol:
These users thanked the author Marcus for the post (total 3):
Sage (Wed May 12, 2021 8:08 pm) • TommyT (Thu May 13, 2021 1:04 am) • dal (Mon Jul 26, 2021 9:37 pm)

User avatar
TommyT
Known User
Posts: 2051
Joined: Tue Oct 15, 2019 4:56 am
Location: Orion Arm of the Milky Way galaxy
Has thanked: 1596 times
Been thanked: 1370 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by TommyT »

Thank You @Marcus That's a chunk of hash. Very nice!
These users thanked the author TommyT for the post:
Marcus (Thu May 13, 2021 8:11 am)

User avatar
KD
Known User
Posts: 2190
Joined: Sun Dec 06, 2020 10:16 pm
Location: Canary Islands
Has thanked: 1081 times
Been thanked: 1570 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by KD »

Nice looking balls mate but from what you described doing, there is a way to further increase the effectiveness of your method.

So first off, when you roll the balls out with a bottle of hot water, you need to squeeze the patty up into a ball and do it again and again until the trichomes have visibly melted. I can see from the grain in the second ball that this needs further work.

Then you should roll it into a ball and wrap it in cellophane like you get for gift wrapping (not cling film) and leave it for 2 months to cure.

I'm sure the third lot will melt down given enough work. The first ball needs more work too so it gets that sexy shine on it.

I deep dived Frenchy Canoli after seeing Polly's balls 😳 have a look on YouTube for his hash masterclass.
These users thanked the author KD for the post (total 2):
Captain Beefheart (Thu May 13, 2021 7:34 pm) • TommyT (Fri May 14, 2021 4:06 am)

Marcus
GR420 Leg End
Posts: 5241
Joined: Thu Nov 29, 2018 2:25 pm
Has thanked: 2463 times
Been thanked: 4662 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by Marcus »

Well @TommyT :rage: ... You gave me the itch to get a hash run on so I've been outside in the pissing rain all morning with my little washing machine.

I am a little moist after the 1st run and my slippers are now on the radiator drying...

Image

:lol: :dance:
These users thanked the author Marcus for the post (total 3):
Captain Beefheart (Thu May 13, 2021 7:34 pm) • TommyT (Fri May 14, 2021 4:07 am) • dal (Mon Jul 26, 2021 9:40 pm)

User avatar
Captain Beefheart
GR420 Leg End
Posts: 7580
Joined: Sat Nov 04, 2017 3:05 pm
Location: on a wet rock in the north sea
Has thanked: 2664 times
Been thanked: 4461 times
Contact:
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by Captain Beefheart »

TommyT wrote:Also I forgot to say:
Thank You to [mention]Mrs Beefheart[/mention] you inspired me to do this.
Aye Bach pollys first run of balls was spot on.if ewe mix the microns together the hash don't make shiny balls it makes dull looking ones,heres 3 balls 25 micron 73 micron and 120 micron she soon be making more fuk the sheep go steady ooh BTW I let the hash dry for 5 days in open air before I workedthem ImageImageImage

great googly moogly!



These users thanked the author Captain Beefheart for the post:
TommyT (Fri May 14, 2021 4:07 am)

User avatar
TommyT
Known User
Posts: 2051
Joined: Tue Oct 15, 2019 4:56 am
Location: Orion Arm of the Milky Way galaxy
Has thanked: 1596 times
Been thanked: 1370 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by TommyT »

KD wrote: ↑
Thu May 13, 2021 9:21 am
I can see from the grain in the second ball that this needs further work.
THIS is what I wanted to know. So I just need to keep working it. OK
@Marcus & @Captain Beefheart
Thank you Guys!
This is awesome and very helpful information!
Thanks!
These users thanked the author TommyT for the post (total 2):
KD (Fri May 14, 2021 2:54 pm) • Mrs Beefheart (Fri May 14, 2021 3:27 pm)

User avatar
KD
Known User
Posts: 2190
Joined: Sun Dec 06, 2020 10:16 pm
Location: Canary Islands
Has thanked: 1081 times
Been thanked: 1570 times
Status: Offline

Re: Tommy's first try at Bubble Hash and Temple Balls

Post by KD »

TommyT wrote: ↑
Fri May 14, 2021 4:11 am
KD wrote: ↑
Thu May 13, 2021 9:21 am
I can see from the grain in the second ball that this needs further work.
THIS is what I wanted to know. So I just need to keep working it. OK
@Marcus & @Captain Beefheart
Thank you Guys!
This is awesome and very helpful information!
Thanks!
You're welcome 😁

The more you work it, the more the trichomes will melt and that's what you're after for a nice shiny ball like Polly makes
These users thanked the author KD for the post (total 2):
Mrs Beefheart (Fri May 14, 2021 3:28 pm) • TommyT (Fri May 14, 2021 9:23 pm)

Post Reply

Return to β€œHashish/Hash Room”